Installation Guide
Installation guide
1
Turn Off Water
Shut off the shower water supply before installation.
2
Remove Old Showerhead
Unscrew your existing showerhead from the shower arm. Use a wrench only if necessary.
3
Clean Threads
Remove any old tape or debris from the shower arm threads.
4
Apply Plumber’s Tape
Wrap the included tape around the shower arm threads to help prevent leaks.
5
Install Connector
Screw the connector onto the shower arm and hand-tighten until secure.
6
Attach Hose
Connect the hose to the connector and tighten by hand.
7
Attach Showerhead
Screw the showerhead onto the other end of the hose and hand-tighten.
8
Turn Water On & Test
Turn the water back on slowly and check for leaks. Adjust if needed.
9
Tip
Hand-tightening is recommended to protect the fittings. Enjoy your cleaner, more refreshing Ozpeakflow shower experience. 🚿✨